Bakersfield will thrive again! Moderated business marketplace list > Venola
> Food and Foodservice
> 9MM mini potentiometers- 500K- circuit bend -pots
9MM mini potentiometers- 500K- circuit bend -pots
These are lots of 11 (!) 9mm mini potentiometers with .157" shafts (9/64" or 3.57mm). They are 500k value linear pots. 31CX505 They can be Board or Surface mounted, as they have both 3 solder lugs and also hex nut hardware.
(Look at how small they are!)They are used, as they were part of somebody's proto-typing project until they realized that they needed a different value pot, at which point they unsoldered all of them. They have never experienced electrical current. The shafts have all been cut off to roughly the same length ( like maybe 5/16" ) and they have solder on 2 of the lugs. Other than that, they just about perfect.
In case you are wondering where to get cool knobs for these, check out this site:
http://webtronics.stores.yahoo.net/knob45kn050.html
I use these all the time in circuit bending because they fit real good into the tight spaces allowed. Also, I dig the knobs that you can get for them. I only have 19 sets of 11, and when they're gone, they're gone
http://home.earthlink.net/~montyman1/ or
http://montyman1.googlepages.com/home
U.S.A.= $2.75 (each additional lot is $0.90)
Canada. = $3.00 (each additional lot is $1.00)
World= $ 4.00 (each additional lot is $3.00)
