Bakersfield will thrive again! Moderated business marketplace list   >   Venola   >   5HP phase converter control panel mill lathe saw

5HP phase converter control panel mill lathe saw


Brand new phase control panel, to be used in conjunction with a 5hp three phase motor. With this setup you will have a 5hp rotary phase converter, your 5hp motor should be rated at 230volt and a rpm of 17XX or 34XX. Please compare and checkout the features of this control panel.
With this setup your converter can not self start itself, if there was a power loss and the power came back on. You would need to press the start button to restart up the converter, if you had a on-off switch setup your converter and your load would try to power up at the same time....which could lead to problems with the converter or load or both.
Heavy duty start capacitors with discharge resistor
Voltage sensing relay that controls the starting circuit of the phase converter.
Power contactor that controls the start capacitor circuit.
Terminal block to connect to your idler motor.
Fuse block that provides protection for the control circuit
If you have any other questions on sizing up or need a different size unit..



5HP phase converter control panel mill lathe saw